Annular Communication Tool
The Annular Communication Tool (ACT) is run with tubing strings and downhole pumps. The ACT has a shiftable sleeve that allows communication between the tubing string and the annular.
A Bullnose (BNS) is a tool placed on the end or bottom of a casing string. It has no flow through capability in order to control pressures and the influx of debris into the liner.
The Carrot Patch Tool (CPT) is an assembly that is installed into the top of an open end existing downhole liner. It provides an interference fit along with thermal movement ability.
Casing Separation Sleeve
The Casing Separation Sleeve (CSS) is an inline casing joint that provides controlled casing failure at its installation location downhole.
Casing Tension Anchor
A Casing Tension Anchor (CTA) is a tool that is installed with a casing string that is to be cemented. It provides the ability to apply a tensile load to the entire casing string to combat against thermal growth.
A Circulating Bullnose (CBN) is a bullnose that allows flow through at the end of the casing to permit circulation and cleanout trips. Upon completion of the task, the CBN is closed by pumping a ball from the surface to shift it closed.
Crossovers & Drive Subs
Block to split points
The Drag Block (DBK) is a tool run in conjunction with other downhole tools that require mechanical rotation to activate. The DBK holds other portions of the string from rotating.
Instrumentation Orientation Swivel
An Instrumentation Orientation Swivel (IOS) is a down hole swivel that provides the orientation of an installed packer that contains instrumentation line connectors. The IOS aligns the packer connectors to the existing casing banded instrumentation lines.
Multilateral Window Level 2
The Multilateral Window Level 2 (MW2) is an assembly installed in casing strings where a sidetrack well is required to be drilled off of the main casing liner. The MW2 is a window junction that does not provide individual well integrity.
Multilateral Window Level 6
The Multilateral Window Level 6 (MW6) is an assembly installed in the casing strings where a sidetrack well is required to be drilled off of the main casing liner. The MW6 is a window junction that will allow for individual well integrity between the sidetrack and the main wells.
No Turn Tool
The No Turn Tool (NTT) is a tool run in conjunction with other downhole tools that require mechanical rotation to activate. The NTT is similar to the Drag Block but holds other portions of the string from rotation.
Profile Nipple Sub
Block to separate points
Rotate and Bend Connection
The Rotate and Bend Connection (ROBE) is installed horizontally drilled wells that have extreme doglegs. The ROBE provides protection to casing failures in these areas.
Swivel Pup Dynamic
A Swivel Pup Dynamic (SPD) is a down hole swivel that provides prolonged simultaneous rotation and reciprocation of a casing string during cementing practices.
Vacuum Insulated Tubing
A Vacuum Insulated Tubing (VIT) is a manufactured joint with an inner and outer tube that provides an insulation between the two tubes. The VIT are installed in thermal wells to provide protection of steam quality reduction during the injection stage.